What is wds ap

Use this mode, e. All associated clients from any AP can communicate with each other like in ad-hoc mode. It allows a wireless network to be expanded using multiple access points without the traditional requirement for a wired backbone to link them. The notable advantage of WDS over other solutions is that it preserves the MAC addresses of client frames across links between access points. Please use decompression software such as WinZip to extract the firmware file to a folder. Do NOT upgrade the firmware via wireless connection.

Please connect the computer to netis router through Ethernet cable. Do NOT turn off the power or cut down the Ethernet cable during the upgrade process. Internet Explorer IE is the recommended browser to upgrade the firmware. Step 1. Open the web browser and type the IP address of the router default: At the router login page, the default username is admin and there is no password.

Note: If you have forgotten this password, you will have no choice but to reset the router to factory defaults. Reset Procedure: With the router powered on, Press and hold the reset button on the back of the router for 10 seconds and release. The lights on the front of the router should all flash and reboot. WDS mode allows the router to act as a wireless multi-point bridge. It functions as a simple OSI layer 2 network device.

In the point-to-multipoint bridge mode, one AP acts as the common link between multiple APs. In this mode, the central AP accepts client associations and communicates with the clients and other repeaters. All other APs associate only with the central AP that forwards the packets to the appropriate wireless bridge for routing purposes.

The Access Point can also act as a repeater. In this mode, the AP serves as a connection between two APs that might be too far apart to be within cell range. When acting as a repeater, the AP does not have a wired connection to the LAN and repeats signals by using the wireless connection. No special configuration is required for the AP to function as a repeater, and there are no repeater mode settings. Wireless clients can still connect to an AP that is operating as a repeater.

When